18's on a 1995 Previa TCR10 - need fitment advice

[replica]

Well, here goes. Hopefully I don't get slapped around too hard. :buck2:

After months of not being able to decide on wheels, I think I have arrived at a decision. Weds Kranze Bazreia :smitten: or something similar. Is there anything similar? LOL

I want to run 225/45-18's, so which width and offset should I get to achieve a zero to mild stretch?

If I run the same width F & R, are the offsets different or the same? Looking for a flush fit with the stock fender flares.

thanks for your help

[replica]

BTW, I plan on dropping it to about a 1-finger gap on all 4 corners.

Which wheels are these? They're similar to the Bazreias....

[ScottyTuned]

Its kinda hard to see but a similar one is:


AME Shallen WX

http://www.ame-wheels.com/wheels/wx/img/shallen_wx_3d_chrome.jpg

SSR Vienna LR7

http://202.164.225.248/lineup/vienna/img/b_vie09_f2.jpg

Kinda looks like AMEs from what I can tell though possibly.

[One Ton VIP]

If you want to stick to a simple bolt-on fitment... just plug and play... then go with an 8.5" with an offset around +42mm to 45mm all around. Shouldn't require any additional work with the 225s. If you are down to roll your fenders.. then figure you can run a good 8-10mm lower offset all around.

[replica]

Sounds good, thanks 1-ton

[JN.FYC]

Scotty.
You beat me to it. :D

[shawnthemonster]

i really like those wheels ;) ;) ;)

[SickazzSpanky]

if you want those AME wheels www.autofashionusa.com is an authorized AME dealer! 858-635-6620 and tose wheels would look sik on your previa! and they can get you custom offsets

[hondaboi]

Hi,

I just wanted to bring this up again, i hope you guys dont mind.

I was wondering if I wanted to use 18x10 with a 35mm offset, will it fit without any mods on the fender or will I need to get flares? If I do need flares, how much are they and where are they available to get?

Also, I read that the max is 8.5wide wheels with around 42-45mm offset with a simple bolt on to be flushed...but I wanna see if its possible if I can fit a really wide wheel on my previa with barely any modifications to the fender?

One more silly question, what does pulling the fender mean?

[shawnthemonster]

i would go with the SSR Vienna LR7's.... theres already going to be a previa with the wx's ;)