will this angle valve stem work for my work euroline dh wheel ?

[TransformCelsior]

my work euroline dh wheel requires a 90 degree angle valve stem.

are all 90 degree valve stems generally the same size ? will this work ?

http://cgi.ebay.com/ebaymotors/four-90-Degree-angle-Chrome-Metal-tire-wheel-Valve-Stem_W0QQcmdZViewItemQQcategoryZ33747QQihZ019QQite mZ8074577379QQrdZ1QQsspagenameZWDVW

[TransformCelsior]

somebody know ?

anyone ?

[OnTop]

there isnt a discount tire around you to try out their stock?
my stems do look just as the ones pictured, give it a try. its only $10

[MS9]

i would say no..

if its like most of the stems i've seen on highend japanese imported wheels, the point where the bend starts is slightly higher than any US stems that i found. and i've tried a lot of em, even the ones in your post..* they also use* a hollow allen wrench type nut on the inside of the wheel to secure the stem. keeps the inside flush.. (unlike the ones found in the US)

plus, i'm assuming that your offsets are not common to the US, so the length of the stems may be specific to your wheel.. you wouldn't wan't to have a long stem sticking out of pass the lip of your wheel.

just order the real stems specific to your wheel model and offset/ size.

==========
here is a pic of the stem that i've seen on imported wheels.. noticed that they don't use any hex nuts (anywhere).. the hollow bottom base screws into the stem with an allen wrench..

[One Ton VIP]

It's best to go to a local source to find the replacement valve stems... that way you can see with your own eyes what exactly you'd need.. I've been able to get "USDM" angled valve stems that work in "JDM" wheels before at even a local generic mexi wheel place. Just gotta go there and check it out yourself if you don't know 100% whether the ebay one will work or not.