ka9 x hydroholics x ssr build thread

[ilive2r011]

yah bro i'll document the progress on the bumper for sure. Want to try to tackle this on my own. So i too have been researching on all the ways to merge the bumpers together. if anyone can help me out on how to combine the 2 bumpers that would be much appreciated.

[xseveredveganx]

Plastic welding it is one way. Another way would be to use a Lord Fusor product along with their plastic reinforcing mesh.

[AME_VIP]

Damn this is nuts! Yah I had like 19x8.5 +23 with 215/35/19 in the rear and it was flush on Anceltion coilovers lol

Good luck!

[ilive2r011]

[ilive2r011]

here is a small update. A lot of work was done to get the front to sit this low.

[NELSON09]

here is a small update. A lot of work was done to get the front to sit this low.

lol @ "small" that's HUUUUUUUUUGE. watching this one.

[ilive2r011]

lol @ "small" that's HUUUUUUUUUGE. watching this one.

lol..the only this stopping us from going lower is the hood and ground at this point haha.

[NELSON09]

lol..the only this stopping us from going lower is the hood and ground at this point haha.

...only acceptable excuse in existance right there. well put.

[OG]

full pics please sir.

[BAHC]

dope, more pics for sure!

[ilive2r011]

I was hoping to have the car done by the wknd but i ran into a few issues. I had to order a pair of wish bone adapters and 2 more large donuts since my kit only came with 2.

[ilive2r011]

full pics please sir.

dope, more pics for sure!

I will get some more pics for sure this wknd.

[Vincent]

HELL YES, greatest update ever. Excited!

[JN.FYC]

i am fucking excited to see this work in progress!!!! Please post lots and lots and lots of pictures of the process.

[ilive2r011]

well there not much to update i didn't get a chance to visit the car. My buddy got all the plumbing done everything is set to go ,just waiting on 2 more parts to come in and the install should be complete

[maxpowerintegra]

ive been gone for a minute but im glad to see another ka9 going ham

[ilive2r011]

[ilive2r011]

Here is an update of the work being done to fit the 18x11's this is with natural camber. Still has way to go as far as getting it all smooth and cleaned up.

I had to order some extensions for the cylinders in order to get maximum lift. With those the lift should be crazy high. I wouldn't be surprised if im able to lift the car 9' of the ground and tuck 30's..lol Everything is going good so far.

[Vincent]

damnnnnnnn progress, glad you got them to fit

[ilive2r011]

Its far from done. The rl has a slight beveled edge as you can see in first picture above i will be looking to keep that. Also since the pull is so aggressive i will pulling the bumper out to match the angle of the pull more as well dialing in the camber more so it angles with the slop of the fender if that makes sence.