Last edited by OG; 05-25-2012 at 06:19 AM.
Damn that's cheap... wish this deal was around when I was still on coils!
Tryin To Make Some Money But My Printers Outta Toner.
i have JIC coilovers for my 2GS..i dont know what size springs to use..but i know what spring rates to go for..any idea what the OTS spring sizes are for JICs?
GO LOW or GO HOME!
JIC FLT-TAR VIP i believe
GO LOW or GO HOME!
dark grey springs?
we've gone direct so i'll get the couple quotes out asap. thanks for being patient fellas, it allows me to offer better service in the long run.
13K/ID62-H200
10K/ID62-H225
i think my rates are 13/8 OTS rates..do you kno what size swift springs i need?
GO LOW or GO HOME!
i believe they are 13/10. the numbers i posted above should be your sizes. lmk what rates you want and i can get you the new part numbers.
been a while since ive been on here.. but im thinkin bout 16k fronts and 14k rears..JIC told me my springs are interchangeable so i might swap my front springs to the rear and just purchase front springs
GO LOW or GO HOME!
your front spring is an inch shorter than your rear so as long as you have an inch of thread above the lower spring perch you're good. we could do 16/13K with just a front swap. it's a tad out of the +2k rule, but i don't think it will be a problem. if you want to send me your zip i can get you a shipped quote. probably looking @ ~$210.
would these springs work on a G50 as supposed to getting new coilovers and modifiying them?
these are replacment coilover springs. i can put some coilovers together for you that take minimal modification depending on your year (less on 90-93, more on 94-96).
fronts are shorter? hmm..so that means i could have less shock travel..although i did lower it about an inch from the spring so i have less travel anyways..maybe i can get full travel by using the shorter spring and raising the perch back up to compensate..pm me the quote for them shipped to 92111..price with rears also in case i decide to cop both sets..thanks OG
GO LOW or GO HOME!
it will not cost you any travel, you'll just need to raise the perch an inch or so. i will work on this quote later today and shoot you a pm.
OG these on megan LP what can you do for rates? factory from megan 12/8
14/10 would be the max recommended, but you can go higher if you wish. keep in mind that the higher spring rate will raise the lowest setting.